Extension Cable for Fuel Leak Detection Sensor
Replace / extend your fuel leak detection with 6m cable
- Detects commonly used fuels
- Rated for hazardous environments
- 6m cable length expandable to 30m
- Replaceable after leak detected
Extend your sensing reach and replace cables after detection with this extension cable for the ServersCheck fuel leak detection sensor.
The IP, Modbus & SNMP based fuel leak cable can detected following fuel types:
|Fuel Type||Typical response time at 20°C|
|#1 diesel fuel||60 minutes|
|#2 diesel fuel||120 minutes|
|JP5 jet fuel||70 minutes|
|JP8 jet fuel||50 minutes|
|Jet-A fuel||50 minutes|
The default cable length is 6m and can be extended to 30 m. The fuel leak sensing cable is designed for single use only.
The fuel leak sensing cable may be used in Class I, Division 2, Groups A, B, C, D Hazardous Locations. If wiring from the module complies with relevant intrinsic safety requirements, sensing cable may be used in Class I, Division 1, Groups A, B, C, D Hazardous Locations (Zone 0 or Zone 1 in Europe).
The fuel leak cable has following certifications:
|Technical Specifications - Fuel Leak Detection Sensor Extension Cable|
|Operating temperature range: 0°C to +75°C in PoE mode|
|Operating humidity range: < 90% rH (non-condensating)|
|RJ45 cable gland protection rating: IP 68|
|Fuel Leak Detection Cable: 6m (single use only)|
|Cable can be extended to 30m|
|Cable cannot be reused after detection and should be replaced|
|Provides a WET/DRY indication in SensorGateway|
|Unit Of Measure||ea|
Be The First To Review This Product!
Help other Duons MCO Pty Ltd users shop smarter by writing reviews for products you have purchased.